General guidance · Saniflo & macerators

Treat the warning as a drainage observation

Saniflo describes Sanialarm as sounding when water in a compatible unit rises above its permitted level. Stop using the connected fixtures and report which one was in use when the warning began. Keep clear of escaping wastewater and electrical equipment in wet areas. Do not flush again just to check whether the alarm repeats, and do not interpret a quiet motor as proof that the water level is safe.

Distinguish the alarm supply from the appliance supply

The accessory uses two AAA batteries; those batteries do not provide the macerator motor’s power. A battery change, an alarm test and a pump repair are therefore different tasks. Follow the exact accessory instructions for owner-accessible checks without opening the wastewater unit. Tell the engineer whether the alarm sounded, whether pumping was heard and whether there was an electrical outage. An absent alarm cannot confirm successful drainage, particularly if its condition is unknown.

Useful observations

  • Record the alarm name as well as the pump model.
  • Keep connected fixtures unused while an active high-water problem is assessed.

Details to include in your enquiry

  • Which fixture was running when the alarm sounded?
  • Was the pump heard at the same time?

An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.

Further information

Your model’s instructions take precedence over general guidance.