General guidance · Saniflo & macerators

Match the flooring arrangement

Saniflo lists Sanifloor+ 1 for tiled wet-room floors, +2 for vinyl, +3 for shower trays and +4 for specified Wedi formers. Identify the installed floor and paperwork before ordering a component. A general photograph should show how the waste sits within the floor or tray, not only a close-up of the removable cover. Do not lift bonded flooring or disturb waterproofing to find a marking.

Separate a surface fitting problem from pumping

A damaged cover, a poor seal around the waste and a pump that does not start are different complaints. Explain which is present and when it appeared. If a recent refurbishment changed the floor finish or tray, keep the installer’s details available. An engineer may need to check compatibility with the existing floor system before a replacement can be agreed. A new pump does not by itself resolve an incorrectly matched or damaged floor connection.

Useful observations

  • Keep floor or tray documentation alongside the pump model.
  • Photograph the waste in its surrounding floor without removing fixed parts.

Details to include in your enquiry

  • Is the surface tile, vinyl, a shower tray or a documented former?
  • Was the waste changed during recent bathroom work?

An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.

Further information

Your model’s instructions take precedence over general guidance.