Keep clear of the leaking unit
Water at the bottom of an electric shower needs careful location, because the hose connection and the casing are different sources. Mira’s guidance says an unresolved leak requires the water and electrical supplies to be isolated and the shower taken out of use. Use only known isolation controls that can be reached safely from a dry position; if that is uncertain, seek urgent professional help rather than approaching wet electrical equipment. Do not remove the cover, continue running the shower for a photograph or block an opening to stop the water.
Give the repair team the visible evidence
Record the model from an existing photograph or paperwork and describe where the first water was seen. Say whether the leak started after a hose change, a new installation or a period of normal operation. Mention an electrical trip or any burning smell without trying to reproduce it. A dry photograph of the overall installation may help identify the correct service route. The next step is to confirm suitable professional assessment of the leak and installation, rather than purchasing a pressure-relief component or seal based solely on the point where water emerged.
Useful observations
- Keep the shower unused while the leak is assessed.
- Do not open the electrical casing or reach into a wet area.
Details to include in your enquiry
- Was water first visible at the hose union or from the casing itself?
- Did any recent installation or accessory change precede it?
An assessment establishes the appropriate work. Leave fixed fittings and concealed connections in place, and do not reproduce an unsafe symptom.
Further information
Your model’s instructions take precedence over general guidance.