Recognise the normal end-of-shower sequence
The Triton Amore operating instructions describe a phased shutdown after the Start/Stop control is pressed. Heating stops first while water continues briefly to clear remaining hot water; the display flashes Bye and then turns off when the sequence finishes. On that model, a few seconds of continuing flow can therefore be expected. Let the documented sequence complete during normal operation, then use the isolating switch as directed in the manual. Do not apply this explanation to every electric shower merely because it has an illuminated display or a similar-looking stop button.
Report a sequence that no longer completes
An outlet that continues flowing, a display that does not finish its sequence or water emerging from the case needs a different response. Stop using the shower and seek help, using only known, dry and safely accessible isolation controls if necessary. Do not block the hose or outlet to stop the water. Record whether Bye appeared, whether the display went off and whether the water eventually stopped by itself. These observations separate the intended flush from an unresolved fault without identifying an internal component. Include the precise Amore model details when arranging assessment.
Useful observations
- Check that the installed model’s instructions describe phased shutdown.
- Record whether the Bye display and water flow both finish.
Details to include in your enquiry
- Does the flow stop after the short shutdown sequence?
- Is the water only from the normal outlet or also from the case?
An assessment establishes the appropriate work. Leave fixed fittings and concealed connections in place, and do not reproduce an unsafe symptom.
Further information
Your model’s instructions take precedence over general guidance.