Record what happens to the lights as well as the water
Mira’s guidance distinguishes a recent installation where flow and lights immediately go off from an established installation where flow stops but lights remain on. For a new installation, it directs the owner back to the installer; an existing unit may need manufacturer repair support. Report which pattern you have already observed, including whether the button returns normally. A shower that only appears to work while a control is held should not be kept running that way. Do not tape, wedge or modify the button to make the shower usable.
Describe any work immediately preceding the change
Mention a newly fitted unit, recent cover removal by an engineer, electrical work or a change that appeared without any recent intervention. Mira places cover-fit and electrical investigation in its expert guidance, so do not tighten casing screws or open an isolator as an owner’s experiment. Keep the full model, approximate installation date and any service paperwork available. These details help route the enquiry to the original installer or an appropriate repair assessment. A short description of the instant stop is more useful than calling it an intermittent shower, which could also mean a different fault occurring after several minutes.
Useful observations
- Note whether the lights go off when the water stops.
- Record whether this is a new installation or an established shower.
Details to include in your enquiry
- Does flow stop immediately on releasing the control?
- Was any installation or service work completed just before it started?
An assessment establishes the appropriate work. Leave fixed fittings and concealed connections in place, and do not reproduce an unsafe symptom.
Further information
Your model’s instructions take precedence over general guidance.