General guidance · Plumbing

Separate sensor response from unwanted continuous flow

An automatic tap may respond to a hand or cloth moving beneath its outlet during cleaning. Hansgrohe directs owners to the individual installation manual for the cleaning-mode procedure on its electronic taps. The sequence is not the same on every sensor model. Note whether the tap behaves normally during hand washing and whether it stops after the usual period. A tap that continues running when nothing is near the sensor needs a different assessment from one triggered only by the cleaning movement.

Use the correct manual rather than a guessed reset

Identify the tap from purchase information or an accessible label without removing covers. Find the cleaning section for that model and check how normal operation resumes afterwards. Avoid covering the sensor with adhesive tape, applying chemicals directly to it or disconnecting unidentified power equipment as a substitute for the documented mode. If the tap remains inactive after cleaning, record the indicator, elapsed time and any steps already taken. Those details help distinguish a temporary setting from a power, sensor or valve problem without dismantling the basin installation.

Useful observations

  • Check whether the problem occurs during ordinary use too.
  • Use the exact model manual for cleaning-mode entry and exit.

Details to include in your enquiry

  • Does water stop normally when the cleaning movement ends?
  • Is a cleaning indicator or timed pause shown?

An assessment establishes the appropriate work. Leave fixed fittings and concealed connections in place, and do not reproduce an unsafe symptom.

Further information

Your model’s instructions take precedence over general guidance.