General guidance · Plumbing

Recognise the intended starting position

Hansgrohe CoolStart taps supply cold water when the handle is centred; moving the lever towards the hot side brings in warm water. The centre position is therefore not the same mixing position found on every other tap. If the fitting has always behaved this way, check its product name or paperwork for CoolStart before assuming the hot connection has failed. Use the normal marked control range gently and keep clear of unexpectedly hot water. There is no need to adjust a cartridge or remove the handle to identify this feature.

Report a change from the tap’s normal behaviour

A tap that previously warmed up in its intended hot position and now stays cold needs a different enquiry from a newly fitted cold-start control. Note whether other hot outlets are working, whether the change followed plumbing work, and whether the lever still moves through its usual range. These observations help distinguish a control expectation from a supply or tap fault without identifying a failed part prematurely. If the model is uncertain, send a photograph of the whole fitting and its markings. A familiar-looking single lever is not enough to establish which control arrangement is installed.

Useful observations

  • Check the tap name for a cold-start feature.
  • Compare the reported problem with its previous normal operation.

Details to include in your enquiry

  • Has the tap always been cold in its central position?
  • Does it still warm up in its normal hot position?

An assessment establishes the appropriate work. Leave fixed fittings and concealed connections in place, and do not reproduce an unsafe symptom.

Further information

Your model’s instructions take precedence over general guidance.