General guidance · Plumbing

Observe without disturbing the fittings

If it is safe, protect the nearby floor and note whether moisture appears while heating, during cooling or continuously. Keep clear of hot surfaces and electrical equipment. Stelrad identifies puddles, staining and corrosion around radiator connections as relevant leak signs. A photograph of the whole radiator and accessible wet area can help show the location without removing a valve head or decorative panel.

Preserve the distinction between a stain and active water

Say whether you have seen fresh water, only a dry rust mark, or repeated dampness after wiping an accessible cool surface. Include any change in the system's pressure reading already observed. Do not tighten unfamiliar nuts, drain the radiator or apply a patch as a diagnostic test. Seek prompt help for an active leak and explain any spreading damage; the assessment should establish whether the problem is a fitting, the radiator body or another nearby source.

Useful observations

  • Note the first accessible wet area and when it becomes wet.
  • Distinguish fresh leakage from an old dry mark.

Details to include in your enquiry

  • Does water appear at a connection or on the panel itself?
  • Is the leak continuous or linked to a heating cycle?

An assessment establishes the appropriate work. Leave fixed fittings and concealed connections in place, and do not reproduce an unsafe symptom.

Further information

Your model’s instructions take precedence over general guidance.