General guidance · Plumbing

Identify the water heater and matching tap together

Hansgrohe explains that an open-vented water-heater tap can release expansion water through its spout during heating. This statement concerns the correct open-vented arrangement; it does not mean that persistent dripping from an ordinary mixer is always normal. Record the heater model, tap details and whether the drip begins and ends with heating. Useful paperwork may identify a low-pressure or vented fitting. If you are unsure what system is installed, say so rather than attempting to identify it by disconnecting hoses or opening the heater.

Keep the intended outlet arrangement intact

Do not plug the spout or add an unverified shut-off accessory to suppress the drip. A replacement tap must be suitable for the heater arrangement, so ask the installer to check both items before ordering. Describe a change from the established pattern, such as continuous flow when the heater is no longer heating, a leak from the casing or water below the cupboard. Those observations should be assessed separately. Include any recent tap or heater replacement because a compatibility question is different from ordinary wear in a correctly matched fitting.

Useful observations

  • Keep both the heater and tap model details.
  • Record whether dripping follows the heating cycle.

Details to include in your enquiry

  • Has the system been confirmed as open-vented?
  • Did the behaviour change after a tap or heater was replaced?

An assessment establishes the appropriate work. Leave fixed fittings and concealed connections in place, and do not reproduce an unsafe symptom.

Further information

Your model’s instructions take precedence over general guidance.