General guidance · Plumbing

Look at the outlet pattern as well as the amount of water

Hansgrohe identifies a dirty aerator as one possible reason for low tap flow. A formerly even jet becoming weak or uneven at one basin is therefore worth comparing with the other outlets already in normal use. This observation does not establish that the aerator is the only restriction. Note whether both hot and cold operation are affected and whether the change followed plumbing work. Check the tap instructions before attempting any owner cleaning; recessed aerators may require a particular key, and a damaged finish should not be gripped with pliers.

Keep cleaning separate from changing the tap specification

Use only the manufacturer’s permitted method and cleaner for the fitted outlet. If the aerator will not release as described, stop rather than applying greater force. Keep any washers and inserts in their original arrangement, and do not remove an intentional flow regulator to obtain a stronger jet. Report whether normal cleaning restored the previous flow or left the restriction unchanged. If neighbouring taps are also affected, explain that wider pattern instead of focusing solely on this outlet. An aerator observation can narrow the enquiry, but it cannot measure the supply pressure available to the property.

Useful observations

  • Compare the affected tap with other outlets used normally.
  • Find the aerator type and owner-cleaning instructions.

Details to include in your enquiry

  • Are both hot and cold flow weak at this tap?
  • Did its jet become uneven before the flow reduced?

An assessment establishes the appropriate work. Leave fixed fittings and concealed connections in place, and do not reproduce an unsafe symptom.

Further information

Your model’s instructions take precedence over general guidance.