Describe the connection that becomes wet
Hansgrohe’s bathroom-tap guidance highlights strain-free S-connections, correct installation dimensions and suitable undamaged seals for an exposed mixer. If water appears where the mixer joins its wall fittings, these details matter to the repair assessment. Record whether one union becomes wet, water appears behind a decorative cover or the wall itself is damp. Do not turn the mixer body or attempt to pull it into alignment. The visible drip does not establish whether the source is a union seal, a fitting behind the cover or another concealed connection.
Mention any movement or recent replacement
Explain whether a new mixer was fitted, tiles were changed or the exposed fitting was knocked before the leak began. If water is escaping during use, stop using the fitting and arrange assessment; use only a known and safely accessible isolation route when needed. Do not use the mixer as a support or apply more force to a union as a general cure. A straight-on photograph of both wall connections helps show the arrangement, while a wider view can show restricted access. The person attending should assess alignment and the correct seals before deciding whether the mixer itself requires replacement.
Useful observations
- Note which wall connection or surrounding surface first becomes wet.
- Report recent fitting, tile work or movement of the mixer.
Details to include in your enquiry
- Is the leak at a visible union or from behind its cover?
- Did it begin after the mixer was replaced or disturbed?
An assessment establishes the appropriate work. Leave fixed fittings and concealed connections in place, and do not reproduce an unsafe symptom.
Further information
Your model’s instructions take precedence over general guidance.