General guidance · Plumbing

Match the waste to the basin construction

Replacement basin wastes need to suit the basin’s overflow arrangement as well as its visible finish. McAlpine’s CWP60-XX instructions, for example, show different assemblies for basins with and without an overflow; the no-overflow arrangement uses a supplied spacer and seal. This is a product-specific configuration, not a universal rule for every waste. Keep the complete fitting instructions and unused supplied components until installation has been checked. Do not discard a spacer merely because the old waste did not have one, or assume that the same chrome top means an identical body below.

Describe where and when the new fitting leaks

If dampness appeared after replacement, note whether it is around the basin outlet, beneath the threaded body or at the trap connection. Photograph the underside and the basin’s overflow opening, if present, without dismantling a wet joint. Explain whether the basin has always drained slowly or the behaviour changed with the new waste. Avoid tightening the assembly harder as a general cure. The installer should confirm the correct configuration, basin thickness and seals for the actual product. This also helps prevent replacing the trap when the mismatch is higher up at the waste fitting.

Useful observations

  • Keep the waste model, instructions and supplied spacer components.
  • Show whether the basin has an overflow opening.

Details to include in your enquiry

  • Was the leak first noticed after fitting a replacement waste?
  • Is the water at the basin outlet or farther down the trap?

An assessment establishes the appropriate work. Leave fixed fittings and concealed connections in place, and do not reproduce an unsafe symptom.

Further information

Your model’s instructions take precedence over general guidance.