General guidance · Electric hobs

Check the destination state

Bosch specifies a destination that is not switched on, has not been preset and has not previously held cookware for this operation. Moving to an already configured zone can therefore prevent the expected offer. Watch for the transfer prompt after the pan is detected, and confirm it using the normal controls. Do not assume an old timer belongs to the new position.

Review the resulting settings

Before continuing the meal, check the selected zone, heat level and time actually shown. If no transfer was offered, set the required cooking operation deliberately according to the manual rather than repeatedly shuffling hot pans. A useful fault description records where the pan started, whether the destination had already been used, and whether a prompt appeared. This distinguishes an unmet transfer condition from a pan-recognition problem or a display that fails to accept confirmation.

Useful observations

  • Use a destination meeting the transfer conditions.
  • Read back the power and timer after confirming.

Details to include in your enquiry

  • Had the destination zone already been used?
  • Was a transfer confirmation displayed?

An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.

Further information

Your model’s instructions take precedence over general guidance.