Stop relying on an unstable attachment
Do not continue a sensor-controlled cook with the accessory slipping down the pot or leaning against another surface. Allow the vessel and sensor to cool, then follow the manufacturer's instructions for the correct replacement patch, surface preparation and setting time. The supplied positioning guide matters because the sensor must sit at the intended height and orientation.
Check the whole attachment arrangement
Keep the sensor identity, hob model and cookware details available when obtaining the correct accessory. A damaged or unsuitable pot surface may prevent a reliable attachment even with a fresh patch. The patch and sensor body have different cleaning permissions, so dishwasher suitability of one does not apply to both. If the attachment repeatedly releases despite the prescribed preparation, seek advice rather than building up layers of adhesive or trying to clamp the sensor against the hot pan.
Useful observations
- Use the specified replacement patch and positioning guide.
- Allow the stated adhesive-setting period before using the vessel.
Details to include in your enquiry
- Did the original patch peel away or tear?
- Was the cookware washed or used before the adhesive had set?
An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.
Further information
Your model’s instructions take precedence over general guidance.