General guidance · Washing machines

Describe when water leaves

Beko identifies incorrect drain-hose positioning as a cause of siphoning. Tell the installer whether the problem began after fitting, moving or changing the sink plumbing. Note whether water appeared to leave while fresh water was entering, and whether the machine repeatedly attempted to refill. These observations are useful even when no error code appeared; they do not prove that the pump or inlet valve needs replacement.

Have the drain route checked

The required height and insertion depth come from the model's installation instructions. Do not copy measurements from an unrelated machine or seal a hose tightly into a standpipe as an improvised cure. Photograph the accessible connection without pulling the appliance out. An installer can check the whole route, including where it joins the building's waste system. Repeated wash attempts waste water and cannot correct a faulty arrangement.

Useful observations

  • Record whether this started immediately after installation or plumbing work.
  • Keep a photograph of the accessible waste connection.

Details to include in your enquiry

  • Does water leave during filling or only during an intended drain stage?
  • Has the hose route or its connection recently changed?

An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.

Further information

Your model’s instructions take precedence over general guidance.