General guidance · Washer dryers

Check the combined-cycle requirements

Read the programme table for the actual model. Its drying capacity is commonly lower than its washing capacity, so a full wash load may need to be divided before drying. Check whether the selected programme included drying and which dryness level was chosen. Many washer-dryers also need their water supply during drying; do not assume that turning the tap off after washing is appropriate. Heat-pump designs have different maintenance requirements.

Describe the result without guessing the repair

Say whether every item is damp or only thick seams and bundled bedding. Include whether the laundry was unusually wet before drying, whether the cycle completed, and any warning shown. If a suitable load and the documented settings still give poor results, the drying and drainage stages need assessment. Stop using the machine for leaks, burning smells or electrical tripping; repeated drying attempts are not a useful diagnostic test.

Useful observations

  • Find the separate washing and drying limits in the model instructions.
  • Record the drying selection and the condition of the load at completion.

Details to include in your enquiry

  • Was this a continuous wash-and-dry programme or a separate drying cycle?
  • Was the water supply left available as the manual requires?

An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.

Further information

Your model’s instructions take precedence over general guidance.