General guidance · Washer dryers

Preserve the distinction for assessment

The guide describes F13 as a dryer temperature-sensing fault, F15 as heater control and F19 as fan-motor or heating related. Applicability depends on the model, and the code is not a parts-ordering instruction. Note whether washing completed, whether the interruption occurred on dry-only or combined operation, and whether the same warning appeared during washing. Give the full model identifier alongside the displayed characters.

Do not repeat heated tests

Hotpoint directs these cases to an engineer. Do not open panels, reset internal devices or select hotter programmes to see which component responds. If the door remains locked after a heated stage, follow normal cooling and release guidance without forcing it. Keep an existing photograph of the code and describe any unusual noise, smell or leak separately. Those observations help the service assessment without needing to reproduce the fault or assume that the drying system's apparent warmth proves correct operation.

Useful observations

  • Record the full code and whether washing or drying was active.
  • Keep the model and already observed symptoms together.

Details to include in your enquiry

  • Did the wash finish normally before the drying warning?
  • Was this the same code on each observed interruption?

An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.

Further information

Your model’s instructions take precedence over general guidance.