Stop rather than encourage the drum
If the drum is visibly stationary during a drying phase when it would normally tumble, stop the machine using its ordinary controls. Do not leave it humming, push the drum into motion or attempt to defeat the door switch. A belt, drive component or obstruction can produce similar customer observations; the sound alone cannot identify the failed part.
Separate a fault from a normal pause
Some programmes include pauses or intermittent movement after drying has finished. Record the programme stage and display wording from the event already observed. Once stopped and cool, remove ordinary laundry only if the door opens normally. Describe any unusually heavy item, trapped garment or new scraping noise. Internal inspection belongs with an engineer, especially if the machine also became unusually hot.
Useful observations
- Keep a short recording of the existing noise if already available.
- Note whether this occurred immediately after pressing Start or later.
Details to include in your enquiry
- Was the display showing drying, cooling or the end of the programme?
- Did the drum stop suddenly during a previously normal load?
An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.
Further information
Your model’s instructions take precedence over general guidance.