General guidance · Tumble dryers

Compare with the intended technology

AEG explains that heat-pump drying can feel different from a conventional condenser dryer, especially early in a cycle. Check the appliance type rather than using your previous dryer's heat as the standard. Do not open the door repeatedly to feel the load; observe the programme and its eventual result.

Notice a genuine change over time

If the same dryer previously completed suitable loads and now consistently leaves them wet, record that change with the programme and room conditions. Warm-up behaviour does not explain every persistent poor result. Keep filter maintenance and starting spin information in the notes. An exact warning, unusual noise or absent drum movement should be reported separately, because those observations are more specific than “not very hot”.

Useful observations

  • Confirm that the appliance is a heat-pump model.
  • Compare complete results rather than brief door checks.

Details to include in your enquiry

  • Is this a new dryer type for the household?
  • Did the same machine previously dry this load successfully?

An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.

Further information

Your model’s instructions take precedence over general guidance.