General guidance · Electric ovens

Separate probe temperature from cavity temperature

Check the actual probe version and follow its diagram: the manual illustrates ET180 and SH253B arrangements, so a generic instruction based only on probe appearance is insufficient. The probe measures the food rather than the surrounding hot air. Use food large enough for the documented insertion and check its position before cooking. An exposed section conflicts with the stated protection requirement and may be relevant when the probe becomes excessively hot. Do not change thermostat calibration to compensate for an incorrectly positioned accessory.

Treat an overheat stop as an interruption

Follow the appliance warning and remove the hot probe with suitable protection as directed when safe. A protective stop is not confirmation that the food has finished cooking. Record the displayed probe reading, how it was positioned and whether the programme stopped with an explicit warning. If the same event occurs with the correct accessory and placement, seek model-specific assessment. Avoid repeating the exposure deliberately to reproduce the fault or handling the probe with bare hands.

Useful observations

  • Match the insertion depth to the exact probe-version diagram.
  • Record a protective stop separately from a target-temperature completion.

Details to include in your enquiry

  • Was any metal shaft exposed to the cavity heat?
  • Did the display identify a probe warning when cooking stopped?

An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.

Further information

Your model’s instructions take precedence over general guidance.