General guidance · Electric hobs

Check orientation before replacing parts

Compare the pan and sensor position with the model diagram. On the supported arrangement, the preferred rim position changes between the left and right sides of the hob. A large pan can also leave the handle farther from the intended receiving area than expected. With cooking safely paused, reposition the sensor as the instructions permit and allow the display time to update.

Separate connection from temperature

A connection symbol describes communication, while the temperature reading describes the sensor's measurement. Photograph both if the behaviour is intermittent. State whether the issue follows the sensor, one pan position or one cooking programme. Do not assume that Wi-Fi or an internet router is responsible: this is the sensor-to-hob link. If the correct position still loses contact, stop relying on automatic temperature control until the cause has been checked.

Useful observations

  • Use the manual's rim-position diagram.
  • Record the connection indicator rather than only the cooking result.

Details to include in your enquiry

  • Which side of the hob holds the pan?
  • Does the indicated signal change when correctly repositioned?

An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.

Further information

Your model’s instructions take precedence over general guidance.