General guidance · Dishwashers

Inspect the cap without force

After the appliance is safely stopped, locate the salt reservoir and check its lid using the model instructions. Miele identifies a lid that is not firmly closed as the reason for this message. Look for visible salt granules around the seating surface and for a cap that has engaged unevenly. Avoid using tools to tighten it beyond the intended hand closure.

Report a message that persists

A cap that will not seat, has damaged threads or gives the same warning despite correct closure needs further assessment. Photograph it before ordering a replacement; superficially similar caps are not a compatibility check. Tell the engineer whether the warning began immediately after filling or during a programme. If the lid opened during a wash, use the manufacturer's specified recovery procedure rather than assuming the load completed normally.

Useful observations

  • Confirm the cap is seated as shown in the manual.
  • Record any visible damage to the lid or its seating surface.

Details to include in your enquiry

  • Was salt added immediately before the warning?
  • Does the lid close squarely without excessive force?

An inspection confirms the fault. Do not dismantle the appliance or reproduce an unsafe symptom to answer a question.

Further information

Your model’s instructions take precedence over general guidance.